Got the MEK6800D2 somewhere in the early eighties. Played with it quite a lot. The last thing I did was to configure it to take a 2708 (by adding wiring for the -5V and +12V lines) so that I could read the contents of my two Tiny Basic EPROMS.
2015-08-29: I dug it out again, unplugged all the chips and cleaned the pins, and plugged the bare basics in again. When unplugging, pin 1 of the 6800 broke off, so I soldered the 6800 into a socket. No joy, however -- nothing on the display. Some time with the logic probe told me that the R/W line is not toggling. Looks like the monitor code is being executed and that the processor is trying to write to the RAM and the PIA but with the R/W line stuck high that's bound not to work.
So I ordered a replacement processor from eBay.
128 Bytes of RAM. Four of these gives half a kilobyte, and a thousand-and-a-bit kilobytes
makes a megabyte, and a thousand-and-a-bit megabytes makes a gigabyte, and if
someone gives you a one gigabyte
memstick right now you'd probably throw it away because it's too small for practical use.
Incidentally, the white text in the paragraph above is 128 bytes.
The MEK6800D2 has a kind of a screwy memory map. Or at least, the address decoding is very
basic. The top three address lines break the memory space into eight 8K blocks, with the
ROM or the RAM or whatever repeated inside that 8K block.
The peripherals are mapped in the 8/9 block which allows a maximum of 32K contiguous RAM -- a lot at the time, but somewhere around 1995 they managed to squeeze that into one chip.
||Back to Wouter's Page||(This page last modified 2016-01-05)|